Install E2C Factory Software

How to Install E2C Factory Software

Software Management

1. Software Acquisition

If the E2C Factory software is not pre-installed on the gateway before leaving the factory, you can install it yourself by following the steps in Section 2. The installation package can be obtained by contacting sales or customer service.

2. Installing the Software

In Robustel's edge computing gateways, the data acquisition software can be installed online directly through the gateway console. The specific operation steps are as follows:

  • Preparation

Prepare the necessary installation package, such as: e2c-factory-x.x.x.x.rpk

  • Step 1

Power on the gateway, open a browser and access http://192.168.0.1. Enter the username (default is admin) and password (default is admin) to log in.

The firmware version information can be viewed from the gateway's WEB home page, as shown in the figure below. Firmware version requirement: >= 2.3.106.

  • Note:

If the version is lower, please contact customer service or sales personnel to obtain the latest firmware for upgrade. For specific upgrade operations, please refer to the "ROSpro User Manual".

  • Step 2

Click [System] - [App Center], select the file, click [Install], and click the "OK" button in the pop-up window to complete the installation. The device will automatically reboot. After logging in again and entering this page, you can see that the APP has been installed successfully.

3. Uninstalling the Software

You can select e2c-factory in [System] - [App Center] to perform uninstallation operations.

Uninstalling APP: Click [System] - [App Center], and click "X".


Click the "OK" button to complete the uninstallation, and the device will automatically reboot.

After logging in again and entering this page, you can see that the APP has been uninstalled successfully.

4. Enabling and Disabling

In the edge computing gateway, the data acquisition software is enabled by default.

Click the Enable toggle switch under [Edge Computing] - [E2C Factory] to switch between enabling and disabling.

5. Entering the Software Main Interface

After the installation is complete, you can find the [Edge Computing] menu item in the left menu bar or at the top. Click it to open the operation page of the E2C Factory software.

The operation page will open in a new tab, presenting the software's main page as shown in the figure below.

    • Related Articles

    • How to Install Grafana on Debian 11

      To install Grafana on Debian 11, follow the steps below. Grafana provides its own APT repository for Debian-based distributions, which ensures you get the latest version. This guide will show you how to install Grafana from the official repository. ...

    • How to Deploy Pareto Anywhere on Robustel EG5120 & Integrate with E2C Factory Web Scada

      Overview In industrial IoT environments, capturing Bluetooth Low Energy (BLE) data typically requires complex integration between hardware drivers and application software. This solution utilizes Pareto Anywhere on the Robustel EG5120 edge computing ...

    • How to Reset Robustel EG Series Gateways to Factory Defaults?

      Overview This guide provides instructions for resetting a Robustel EG series edge computing gateway (e.g., EG5120, EG5200) running RobustOS Pro to its factory default state. A factory reset is a powerful troubleshooting step used when a device is ...

    • How to Install KNX API Server on Robustel EG5120

      Overview The Robustel EG5120 edge computing gateway is a high-performance industrial edge computing gateway. Robustel is proud to be the first manufacturer globally to achieve official KNX API Server certification, providing a standardized, secure, ...

    • How to Activate E2C Trinity Software License

      How to Activate E2C Trinity Software License Document Header Field Value Product E2C Trinity Document Type Knowledge Base Article Intended Audience All E2C Trinity users who need to activate or upgrade their software license Prerequisites A valid ...